[. . . ] NOTE: This procedure provides step-by-step instructions for installing a desktop LTO-2 Half-Height drive. Please refer to the other side for instructions on installing an internal version of the drive. Please read the instructions completely before beginning the installation process. Copyright © 2004 by Certance LLC. [. . . ] · Due to the speed of the LTO-2 Half-Height drive, it is recommended that a maximum of one LTO-2 drive be connected to one host SCSI adapter. NOTE: This procedure provides step-by-step instructions for installing an internal LTO-2 Half-Height drive. Please refer to the other side for instructions on installing a desktop version of the drive. Please read the instructions completely before beginning the installation process. Before installing the drive, read the following instructions: · Install LVD drives only in an LVD environment. · Due to the speed of the LTO-2 drive, it is recommended that a maximum of one LTO-2 drive be connected to one host SCSI adapter. If any item is damaged, please contact your place of purchase immediately. If another SCSI device in the SCSI chain is using this ID, either use the push-button switch on the back of the drive to change the drive's SCSI ID or assign a unique SCSI ID to the other SCSI device. Before changing the SCSI ID on the tape drive, turn off the tape drive. Attach the SCSI interface cable to either of the two 68-pin SCSI interface connectors on the back of the drive. Power connector Drive configuration jumper pins Library Interface Connector 1. If any item is damaged, please contact your place of purchase immediately. The drive's default SCSI ID is 6 and terminator power is disabled. · To enable terminator power, place a jumper across pins 11 and 12. Select an available 5. 25-inch, half-height mounting bay for the drive. · For vertical mounting: the side of the drive should be within 5 degrees of horizontal. · For horizontal mounting: the base of the drive must be within 15 degrees of horizontal and the drive must be right-side up. Secure the drive using two M3. 0 X 3 metric screws on each side of the drive. [. . . ] If you use this default setting, place a SCSI bus terminator or a SCSI device with termination enabled at the end of the SCSI chain. Note that the drive provides terminator power if a jumper is placed on the termination power jumper pins (see step 4 and Figure 2). Attach a 4-pin power cable to the power connector on the back of the drive (see Figure 1). [. . . ]